Written brief
The form on this page is the controlled channel. Specification, quantity, destination, and timing travel together.
SEND A BRIEF
LinkScope Sourcing 28
This page keeps the communication path in a card row and the form in a band underneath. The inquiry dialog elsewhere is only a narrow box. Here you can see the steps while you write the harness construction.
Reply path
The work email you type is where the desk writes back. No separate mailbox is published on this site.
Phone and hours
A phone number is not published, because a call drops the construction fields. Briefs are read on US business days. A timestamp is not a ship date.
Social and map
No social account is used for quotations. The illustration is a review bench, not a street address and not a pin you should visit.
- You submit conductor, gauge, connector, jacket, quantity, destination, and timing.
- The desk checks whether those cells are complete enough to send outward.
- Factories that receive the packet answer on that basis. Deviations come back as deviations.
- You compare the replies. This site does not select the factory for you.
What to put beside the harness question
Conductor metal, gauge, core count, connector series, plating, jacket, shield, and the test rows you need. Quantity in assemblies, pieces, feet, or meters. Destination. Expected timing.
An optional budget needs a currency and a basis: per assembly, per piece, per meter of cable, or the whole order. High-end, mid-range, budget, or undecided describes the kind of factory response you want. It is not a score this desk has verified, and you can send the brief before any factory has priced it.
If a drawing will not fit in the form, say so in the requirement field and send the file after the initial reply. The form itself has no upload control. Useful figures to type, when you know them, include 18 AWG or 22 AWG, a seal question such as IP67, a hipot question such as 500 VDC or 1000 VDC, and a bend-radius question for the bundled section. Leave a cell blank rather than guessing. Reference questions gathered on 2026-10-27 do not replace the supplier datasheet for the exact terminal and housing.
Also separate 50 ohm from 75 ohm, a 2 m tail from a 0.5 m jumper, and a lot of 5 assemblies from a lot of 200 assemblies. Connector mating cycle, ingress protection, insertion loss, return loss, impedance, VSWR, wavelength, optical budget, frequency range, and gain are row names, not values this page fills in. Power over Ethernet wattage, dispersion, receiver sensitivity, and transmit power belong to the host. Write them only when that host is in the buy. Measurement accuracy and calibration traceability of hipot gear stay as questions to the named lab. If you want an OEM drawing quoted, say the revision. If you will accept a compatible proposal, mark the cells that may change, including gauge and plating.